binary: not sure if i will be modifying it any during the rebuild, hank suggested cam and porting, but i dont know of a place that will port cause i havent looked into it yet and i dont know where to get the oversized cam, didnt see them on roverparts.com (not even stock) which is where i was looking for gaskets and hoses and all that other stuff.
hank: i am working out getting the heads checked right now and they should be going to the machine shop soon. can you explain to me what could have happened to the block that is not visible? could the block have warped? before the heads? and without blowing the head gasket? everything looks good, and it turns over smoothly, all pistons move nicely and smoothly. Connecting rods look good and are solid, cylinder walls appear smooth. Crank shaft bearing caps are not discolored so as far as we can tell it did not spin a bearing. Timing appears to be correct. Im new to this and I don’t understand, what could have happened to the block.
|
