Quote:
|
Originally Posted by Elemental
I have never seen one rover set with base adle correct from the factory.
I dont see blocking off the bypass hose in your proceedure.
Try this.....
1. Turn off all electrical accessories.
2. Connect an accurate tachometer (do not use vehicle tachometer).
3. Clamp idle speed control air bypass hose.
4. Observe idle speed; it must be 525 +/- 25 rpm.
5. If idle speed is not correct, remove tamper-proof plug from idle speed bypass screw.
6. Adjust idle speed until correct.
7. Remove clamp from bypass hose.
8. Replace tamper proof plug.
9. If MIL code 48 sets, reset code.
|
Thanks
that's what I was looking for
bob
