I'll either rip the front Spring out and send them away to get reset or the manufacturer will make me another set at cost price I did a bit of an experiment with a few sand bags on the front bar to replicate winch and battery and at 60kg the suspension dropped about 15mm and then I did the same at the rear to replicate a Cargo draws and the extra from when I'm
going away at 160 kg the back dropped about an 1 inch so the rear
measured about a little over 3 inch and this meant that the front
was now a little over 4 inch
so the plan is to put in a set of D1 rear spring seats I'm told that
will give me 15mm extra for the rear so at fully loaded the rear
will sit 3.5 inch and the front I'm dropping by an inch to sit a tat
over 3 inch
I think
