SELECTOR POSITION SWITCH
Remove
Raise vehicle on four post lift. Select 'P'. Raise lift.
Remove nut securing selector lever to selector shaft. Release lever.
Release switch multiplug from bracket. Disconnect from vehicle harness.
Remove nut and bolt securing position switch.
Release switch from selector shaft. Remove breather hose.
Remove switch. Refit
Ensure 'P' is selected by rotating selector shaft fully clockwise.
Engage 'N' by rotating selector shaft anti-clockwise by 2 detents.
Connect breather hose to switch. Connect multiplug to vehicle harness. Secure to bracket.
Engage switch on selector shaft. Fit nut to stud, fit bolt. Do not tighten.
Fit setting tool LRT-44-011 to shaft. Insert setting pin into tool.
Rotate switch until setting pin engages with hole in switch as shown.
Tighten nut and bolt. Remove setting tool.
Fit selector lever to shaft. Secure with nut.
Lower vehicle.
