Injectors
When removing the rail goes easy on it.I would recommend removing the upper plenum and velocity stack plenum. I would also remove the injector clips and the four nuts that hold the rail down and gently prying the rail up a little bit at a time alternating on each corner of the rail.Some injectors might stay in the manifold and some may stay in the rail. After the rail is removed you can deal with the injectors. Always use new o-rings and gently install all the injectors and put the clips back. I would also test the injectors before installing the rail by cycling the key and viewing for seal leaks.
Could you tell me what type of injectors you are ordering from FiveOMotors ?
I want to order a set also.
Take care,Good luck.
|
