I just installed a custom crower cam in my 4.6 (99 D2).
I got the entire kit from Mark at D&D (aluminumv8.com).
I have a distributorless motor which uses a cam position sensor and crank position sensor for timing.
The kit included the cam, lifters, timing chain and sprockets (upper sprocket modified with reluctor plate for cam sensor) as well as the spacer needed to space the cam sensor back a bit.
Great low end torque.
He makes this setup for Bosch as well as GEMS applications.
It may be alot less for your application as you would not need those extra bits if you have a distributor. Mark will be able to tell you what you need.
I put mine in while rebuilding my engine, but I understand that it can be done while in the vehicle. The radiator and AC condensor will have to be removed for access, but I have read that someone was able to just unbolt the condensor and tie it out of the way, so the lines would not have to be disconnected (requiring a recharge of refrigerant).
Mark was also able to supply me with all the gaskets I needed except the one for the upper air intake (D2 only I think).
I think the whole kit was $450 plus gaskets.
His prices are pretty good.
Dan
|
