Obd2 - Land Rovers Only

acornhoek · 08-16-2006, 06:32 PM

Is there a connector for OBD2 in a '97 D90?

Disco Mike · 08-16-2006, 07:43 PM

Sure there is, i haven't hooked into one, but I am assuming the is down under the steering column kije all other Rovers.
Do you have a check engine light on?
Mike

Art Vigil · 08-16-2006, 10:47 PM

is right behind the coin tray at the top of the center console (see the photo)

acornhoek · 08-17-2006, 06:52 AM

Thanks gentlemen.............

Disco Mike · 08-17-2006, 07:10 AM

Well, I missed on the location, never had to check one on a D90, glad I know know where to look.
Mike

Art Vigil · 08-17-2006, 09:10 PM

I used to reset my light nearly as often as I fueled up.

Next D90 I get will be '95 or older (pre OBDII) - much more simple.

~Art

Geobloke · 08-18-2006, 06:57 AM

What is a OBDII???

acornhoek · 08-18-2006, 01:15 PM

OBD2 - On Board Diagnostics 2 (there was a version 1).

OBD2 is required on all vehicles sold in the USA from 1996 forward.

Everything from a D90 to a Ferrari to a Ford has the same connector that when plugged into will reveal the fault codes stored or pending in the computer.

08-16-2006, 06:32 PM	#1 (permalink)
acornhoek Getting the mud off..... Join Date: Jan 2006 Location: OKC Posts: 962 Gallery: 0	Obd2 Is there a connector for OBD2 in a '97 D90? __________________ ’61 IIA 88 \| ’63 IIA 88 \| ’69 IIA 109 Carawagon \| ’98 D1 \| ’96 D1 5spd \|'97 D90

08-16-2006, 10:47 PM	#3 (permalink)
Art Vigil Senior Member Join Date: Aug 2005 Location: Denver City, CO USA Posts: 153 Gallery: 0	OBDII Connector... is right behind the coin tray at the top of the center console (see the photo) Attached Thumbnails __________________ Denver City, CO USA '95 RRC SWB TWR Edition '72 Series III 88" (Rita) '97 D90SW #2426 (sold 3/05) '95 D90ST #2620 (sold 10/01)

08-17-2006, 06:52 AM	#4 (permalink)
acornhoek Getting the mud off..... Join Date: Jan 2006 Location: OKC Posts: 962 Gallery: 0	Thanks gentlemen............. __________________ ’61 IIA 88 \| ’63 IIA 88 \| ’69 IIA 109 Carawagon \| ’98 D1 \| ’96 D1 5spd \|'97 D90

08-17-2006, 09:10 PM	#6 (permalink)
Art Vigil Senior Member Join Date: Aug 2005 Location: Denver City, CO USA Posts: 153 Gallery: 0	I used to reset my light nearly as often as I fueled up. Next D90 I get will be '95 or older (pre OBDII) - much more simple. ~Art __________________ Denver City, CO USA '95 RRC SWB TWR Edition '72 Series III 88" (Rita) '97 D90SW #2426 (sold 3/05) '95 D90ST #2620 (sold 10/01)

08-18-2006, 06:57 AM	#7 (permalink)
Geobloke Senior Member Join Date: Jan 2005 Location: Edmonton, Canada Posts: 808 Gallery: 0	What is a OBDII??? __________________ 1992 K-reg 200TDI Defender 90 (Eva) Curlew Woods - Wooden Stuff Northern Alberta 4WD Association LRUK Forums TriumphTR7.com Wetroads Geocaching MSN - Geobloke@hotmail.com There are a terrible lot of lies going around the world, and the worst of it is half of them are true. Sir Winston Churchill

Remove Advertisements Sponsored Links
Land Rovers Only - Land Rover Forum Advertisement

08-16-2006, 07:43 PM	#2 (permalink)
Disco Mike Moderator Join Date: Aug 2004 Location: Parker, Colorado Posts: 5,771 Gallery: 0	Sure there is, i haven't hooked into one, but I am assuming the is down under the steering column kije all other Rovers. Do you have a check engine light on? Mike

08-17-2006, 07:10 AM	#5 (permalink)
Disco Mike Moderator Join Date: Aug 2004 Location: Parker, Colorado Posts: 5,771 Gallery: 0	Well, I missed on the location, never had to check one on a D90, glad I know know where to look. Mike

08-18-2006, 01:15 PM	#8 (permalink)
acornhoek Getting the mud off..... Join Date: Jan 2006 Location: OKC Posts: 962 Gallery: 0	OBD2 - On Board Diagnostics 2 (there was a version 1). OBD2 is required on all vehicles sold in the USA from 1996 forward. Everything from a D90 to a Ferrari to a Ford has the same connector that when plugged into will reveal the fault codes stored or pending in the computer. __________________ ’61 IIA 88 \| ’63 IIA 88 \| ’69 IIA 109 Carawagon \| ’98 D1 \| ’96 D1 5spd \|'97 D90

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode