This just came in yesterday. Mileage is a little on the high side at 143K but there have been tons of new parts installed over the last few years and it shows by the way this truck runs. The engine was showing code P1590 for ABS and a couple of O2 sensor codes but otherwise runs like a top. If you need a Non SAI Bosch 4.0L you can have this one cheap!
The bumper was cracked in a few places but the rear bumper is perfect (wish I could say the same about the bumper tail lights). New front driveshaft with less than 25 miles of use and minor surface rust as the truck sat since it was installed in November. Transfer case has the nipple. No linkage though. Power steering pump has been sold.
We did 32 Rovers last year so we have an extensive inventory of parts on hand. Let me know what you need.
Hey Paul , Need a price on a serviceable front driveshaft ..Not factory stuff but aftermarket..Been a while since i ordered from ya . Also looking for decent D1 wiper arms , just let me know , thanks in advance ...
__________________
current vehicles : 96 Discovery-1 SE7. stock besides 255-70-r 16 ... SOLD
2000 Discovery-2 SD ...2 in OME 763 and 779 springs factory roof rail extensions , flat rack with 500ff's,hella 500's, .. new heads and head gasket . power steering pump , water pump . 265/75R16 guard dogs
looking for motor 4.0 do you know if its good a far as cracks go and do you have a price ?
Jamie Doeren
920-562-0002
Hi Jamie,
I'd sell the motor for $500 but I think shipping is going to be the deal breaker. I'm in CT and you're in CA. I would expect shipping to a commercial address with access to either a loading dock or fork lift is going to be in the $300-400 range. If you're not discouraged by that let me know.
Cheers,
Paul
This is the front driveshaft that was on the truck. The guy I bought the truck from said he installed it in November and then the starter went on the truck. So it sat out in New England weather for a couple of months getting its share of surface rust. He said the driveshaft probably didn't have more than 25 miles on it. If anyone can identify the driveshaft please do. It's looks beefier than the original and all the u joints have zerk fittings.
Looking for a working fuel pump with the sending unit. My sending unit is dead! Could also use the drivers side rear corner piece. Front ashtray or coin holder, rear cup holder that sits in arm rest and piece that sits in the center console back seat near the vent. Thank
Looking for a working fuel pump with the sending unit. My sending unit is dead! Could also use the drivers side rear corner piece. Front ashtray or coin holder, rear cup holder that sits in arm rest and piece that sits in the center console back seat near the vent. Thank
I have fuel pumps for trucks w/o secondary air injection, I have left rear bumperettes if that's what you mean by the corner piece and front ash trays or coin trays, whichever you prefer. The cup holder assembly for the center arm rest on the rear seat doesn't really replace all that easily but I do have complete arm rests with working cup holders you can purchase in Bahama Beige, Lightstone or Granite Grey. I'm not sure about the last item on your list. If it's the ash tray that mounts in the back of the center console for use in the rear seat, I am currently our of stock. Let me know if I've got the list right, where the parts are going (zip code) and I'll get you a price. Thanks
The AutoGuide.com network consists of the largest network of enthusiast-owned enthusiast-operated automotive communities.
AutoGuide.com provides the latest car reviews, auto show coverage, new car prices, and automotive news. The AutoGuide network operates more than 100 automotive forums where our users consult peers for shopping information and advice, and share opinions as a community.
1/16/13 Parting 2001 DII SE Java Black
Linear Mode
