D1 Front Lamp Guards

[mick968]

I just acquired a( used )set of the front(headlight) lampguards(not brushguard but grill type that mount on headlight assembly) and they didn't come with mounting hardware(and obviously no instructions).Thought installing would be no brainer but can't quite figure out what they mount on or how they mount to the vehicle.Anyone have experience installing or pics of mounted front guards on vehicle?Haven't seen too many(Discos) with these(a couple of RangeRovers).Need a visual to get started rigging or customizing my installation.

[Ultraviolet]

not sure if the d1 and d2's or the same but here is my d2 sorry crappy shots from my phone. you have to drill into the wing and the grill and use bolts, don't use self tapping screws the metal is to thin. unscrew the rad support and pull forward on the grill to get those. not too bad took about an hour.

[mick968]

Thanks for feedback.The one's I have are different(all metal)(less finished looking).After I post this question my brain kicked in and remembered Atlantic British usually has instructions for assembly or mounting on their website so I went their and sure enough it showed(missing tabs/hardware) and that it mounted to existing OE bumper(my bump lost a battle with a deer and has been replaced by Rockstar Fab unit).So,as usual something that appeared to be a very easily installed add on will be a time consuming CF that will involve some engineering to make functional.Always something.