Is there any other place that does mods as much as Rovertym

[ROVERNIT]

Originally Posted by p76rangie

You are the one who has placed the order.
Normally with ordering Dobson custom springs you have to tell them a few things. Firstly, the compression rate of the springs that you currently have on. Secondly, the uncompressed and compressed lengths. These, two questions tell them how much weight you currently have on the spring. Thirdly, you will tell them how much lift you want and what springs you want. They will then make up the springs to suit. But as you are about to put a bull bar, etc on your car, you should wait until they are on.
Without knowing the weight of your vehicle, the spring weights that you are suggesting would raise the vehicle by around 2 inches without any extra length. So I would suggest that the springs that you end up with will be about 2 inches longer.

When I asked Dobinson what they would recommed for a spring that would lift the vehical approx 4 inch they asked do you have a bull bar ect ect and according to that 240 and 280 where there rates they recommended I wanted a little softer on the front so I said 220ibs as recomended from another from member on AULRO

Not to bring Simon in on it but his spring rates are 240 and 300 so again I hope its OK

should these be wrong and not sit right then i'll have to bite the bullet and order another set