Coil Spring Conversion... HELP!!! - Land Rovers Only

randy_purnell · 02-12-2007, 08:57 AM

Hey guys, I purchased the BlackDog coil spring conversion online and cant find the directions to overide the module. Does anyone have the directions from their BlackDog kit to fax me. Please Help.

925.750.9096 fax

Disco1 · 02-12-2007, 02:56 PM

Hi,

Locate the EAS control module beneath the drivers seat. (This will be the lowest module, beneath the transmission control module.)
Disconnect the module connector.
In the wiring harness leading to the module, locate the BLUE wire with the PINK stripe.
Cut this wire and permanently ground.
Locate the BLUE wire with the WHITE stripe and temporararily ground.
Turn the ignition to the "RUN" position.
Listen for the audible alert, then remove the BLUE/WHITE wire from the temporary ground and tape up the end to avoid shorts.
This will put the module in EAS Manual mode.
Leave module connector unplugged.

Phew !!!!

randy_purnell · 02-13-2007, 08:59 AM

Thanks for the info Disco1.

02-12-2007, 08:57 AM	#1 (permalink)
randy_purnell Member Join Date: Feb 2007 Posts: 2 Gallery: 0	Coil Spring Conversion... HELP!!! Hey guys, I purchased the BlackDog coil spring conversion online and cant find the directions to overide the module. Does anyone have the directions from their BlackDog kit to fax me. Please Help. 925.750.9096 fax

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Land Rovers Only - Land Rover Forum Advertisement

02-12-2007, 02:56 PM	#2 (permalink)
Disco1 Member Join Date: Aug 2004 Location: Colorado Posts: 82 Gallery: 0	Hi, Locate the EAS control module beneath the drivers seat. (This will be the lowest module, beneath the transmission control module.) Disconnect the module connector. In the wiring harness leading to the module, locate the BLUE wire with the PINK stripe. Cut this wire and permanently ground. Locate the BLUE wire with the WHITE stripe and temporararily ground. Turn the ignition to the "RUN" position. Listen for the audible alert, then remove the BLUE/WHITE wire from the temporary ground and tape up the end to avoid shorts. This will put the module in EAS Manual mode. Leave module connector unplugged. Phew !!!!

02-13-2007, 08:59 AM	#3 (permalink)
randy_purnell Member Join Date: Feb 2007 Posts: 2 Gallery: 0	Thanks for the info Disco1.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)