New month, New problem...doh!

[prettynpink1029]

Originally Posted by Roverhound

To do it right the SLABS module needs to be reprogrammed so it's not trying to run the air pump. This will also prevent any faults associated with self leveling from popping up.

Hi Roverhound,

I'm assuming what you're saying means about $100 out of my pocket to someone that has the TestBook computer to do it. I'm trying to take the cheap way out... but I don't want to pull the fuse and lose my ABS with the Self Levelling. Since the pump just started to function somewhat again, could I put in another SLS pump that I have laying around that is shot and avoid any further $$ out of my pocket. I know it's not the "right" way to do it, but it seemed to work fine before. Am I having this problem because the SLS pump is working again? and by putting in another defective pump will that put things back to how it was before? Thanks for your patience, when it comes to electrical I really don't have a clue.

Heather

[Roverhound]

Originally Posted by prettynpink1029

Hi Roverhound,

I'm assuming what you're saying means about $100 out of my pocket to someone that has the TestBook computer to do it. I'm trying to take the cheap way out... but I don't want to pull the fuse and lose my ABS with the Self Levelling. Since the pump just started to function somewhat again, could I put in another SLS pump that I have laying around that is shot and avoid any further $$ out of my pocket. I know it's not the "right" way to do it, but it seemed to work fine before. Am I having this problem because the SLS pump is working again? and by putting in another defective pump will that put things back to how it was before? Thanks for your patience, when it comes to electrical I really don't have a clue.

Heather

When I get a chance I'll take a look at the electrical prints and see if I can find anything.
I have a fault free SRD 000070 SLABS module that is programmed without self leveling.
This should eliminate any faults you are getting from the SL stuff.
This is from my 2000 D2.
PM me and we can work something out if you want it.

[prettynpink1029]

Originally Posted by Roverhound

When I get a chance I'll take a look at the electrical prints and see if I can find anything.
I have a fault free SRD 000070 SLABS module that is programmed without self leveling.
This should eliminate any faults you are getting from the SL stuff.
This is from my 2000 D2.
PM me and we can work something out if you want it.

Thanks Roverhound. I'll let you know if I'm interested.
Heather

[helievacpilot]

Heather. The ONLY way to solve your problem once and for all is to have the SLABS re-programmed or buy and install a non-sls SLABS module. Otherwise, you'll be constantly chasing that voltage loss.
- Bill