Rear Bumper End Cap/Finisher

[2001SE7]

Hello,
I need to remove the rear bumper corner end cap/finishers on my Disco II. I've tried to find some pointers before I start. No luck so far... I'm afraid of busting them. Any "how to" would be appreciated. Thank you.

[Bosnian Discovery]

I believe you have to remove the bumper to get to the screws that hold it in place. Don't quote me on that - I haven't had a factory bumper for a while.

Look up the process in the free RAVE manual:

land rover service factory manual RAVE download land rover resource, service manual, workshop factory manual, download, rave, vehicles including discovery, series, defender, range rover, freelander, LR3, Handbooks, Catalog, Catalogue, Land Rover Inte

[01discoj]

If you can get to the screw on the side of the end cap between itself and the bumper then its just a matter of prying them off. They are held on there by one screw and clips.

Sent from my MB520 using AutoGuide.Com Free App

[2001SE7]

Originally Posted by Bosnian Discovery

I believe you have to remove the bumper to get to the screws that hold it in place. Don't quote me on that - I haven't had a factory bumper for a while.

Look up the process in the free RAVE manual:

land rover service factory manual RAVE download land rover resource, service manual, workshop factory manual, download, rave, vehicles including discovery, series, defender, range rover, freelander, LR3, Handbooks, Catalog, Catalogue, Land Rover Inte

I've looked all through RAVE... can't find it. That's why I came to the forum. Hoping the part is strong enough to take a little prying. I guess I'll drop the bumper 1st... cause I don't see any screw. Thanks.

[2001SE7]

Originally Posted by 01discoj

If you can get to the screw on the side of the end cap between itself and the bumper then its just a matter of prying them off. They are held on there by one screw and clips.

Sent from my MB520 using AutoGuide.Com Free App

Thank you, got it off. 1 clip broke but I happen to have an extra one. Thanks again.