Tcase and Tranny breather line - Land Rovers Only

WessDisco · 05-11-2006, 08:46 PM

Hey All.....
I need to replace my breather lines on my tcase and tranny on my 01disco II....They were melted for some reason. I would like to extend them up higher to help with water issues.....What would be the best type of hose or line to use, and where should it be ran to, to reach a higher level....Thanks

Badger1 · 05-12-2006, 04:52 AM

I just used an old D1 kit from Mantec that I had laying around for my wifes D2, don't know exactly what type of hose it is. attatched the extended lines with a short length of rubber hose and ran the Xcase, trans, and front axle through an already existing hole in the firewall and up the A pillar under the trim. For the rear just take out one of the tail lights and feed the line up and attatch somewhere with a zip tie. Just make sure whatever you do go with that it doesn't melt too easy.

Disco Mike · 05-12-2006, 07:39 AM

Check out Atlantic British or Rover connection, I believe that have long replacement hose kits.
Mike

05-11-2006, 08:46 PM	#1 (permalink)
WessDisco Member Join Date: Apr 2006 Posts: 13 Gallery: 0	Tcase and Tranny breather line Hey All..... I need to replace my breather lines on my tcase and tranny on my 01disco II....They were melted for some reason. I would like to extend them up higher to help with water issues.....What would be the best type of hose or line to use, and where should it be ran to, to reach a higher level....Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Land Rovers Only - Land Rover Forum Advertisement

05-12-2006, 04:52 AM	#2 (permalink)
Badger1 Forward! Join Date: Jul 2005 Location: Loo-eee-ville, KY Posts: 2,163 Gallery: 1	I just used an old D1 kit from Mantec that I had laying around for my wifes D2, don't know exactly what type of hose it is. attatched the extended lines with a short length of rubber hose and ran the Xcase, trans, and front axle through an already existing hole in the firewall and up the A pillar under the trim. For the rear just take out one of the tail lights and feed the line up and attatch somewhere with a zip tie. Just make sure whatever you do go with that it doesn't melt too easy.

05-12-2006, 07:39 AM	#3 (permalink)
Disco Mike Moderator Join Date: Aug 2004 Location: Parker, Colorado Posts: 5,785 Gallery: 0	Check out Atlantic British or Rover connection, I believe that have long replacement hose kits. Mike

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)