Boge Unit Removal - Land Rovers Only

Triple R · 05-08-2007, 11:14 PM

Does anyone know the size spanner required to remove the lower portion of the Boge unit. Shop manual says thin wrench but does not say which size and would love to know before getting under there. Thanks Guys.

DougG · 05-17-2007, 11:14 AM

Are you taking it off to put a new one on, or are you just removing it completely? If the latter, I used a 4.5 inch angle grinder to cut the thing out

Not sure what size spanners to use though

Triple R · 05-19-2007, 06:29 AM

Had it taken off already,I have to replace the ball joint on the A-arm (clunking).Thought it was the ball joints on the Boge unit. I have the heavy duty springs so I really dont need the self leveler. Curious to see how it rides without the Boge. Figured while i am replacing the ball joint I will do the bushings on the A-arm too. Did not want to cut it just in case I want to re-install it.Time will tell. Thanks for the reply,appreciate it.

05-08-2007, 11:14 PM	#1 (permalink)
Triple R Member Join Date: Jun 2005 Location: NYC Posts: 55 Gallery: 0	Boge Unit Removal Does anyone know the size spanner required to remove the lower portion of the Boge unit. Shop manual says thin wrench but does not say which size and would love to know before getting under there. Thanks Guys.

05-17-2007, 11:14 AM	#2 (permalink)
DougG Member Join Date: May 2006 Location: Cooperstown NY Posts: 77 Gallery: 0	Are you taking it off to put a new one on, or are you just removing it completely? If the latter, I used a 4.5 inch angle grinder to cut the thing out Not sure what size spanners to use though __________________ Doug 61 Series II 109 SW 88 Range Rover Classic SWB 96 Range Rover P38

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Land Rovers Only - Land Rover Forum Advertisement

05-19-2007, 06:29 AM	#3 (permalink)
Triple R Member Join Date: Jun 2005 Location: NYC Posts: 55 Gallery: 0	Had it taken off already,I have to replace the ball joint on the A-arm (clunking).Thought it was the ball joints on the Boge unit. I have the heavy duty springs so I really dont need the self leveler. Curious to see how it rides without the Boge. Figured while i am replacing the ball joint I will do the bushings on the A-arm too. Did not want to cut it just in case I want to re-install it.Time will tell. Thanks for the reply,appreciate it.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)