valence question - Land Rovers Only

campbell · 12-28-2006, 05:21 PM

Does anyone know how involved it is to remove the valence panel on a 95 RRC? i am planning on using the existing fog light harness and wiring to put in aux. lights in the mounting holes on top of the bumper, but I cant figure out hoe to bolt them on without taking the bumper off? There is no way to thread the respective lock washer and nut without doing so.

Any advice?

choffa@comcast.net · 12-28-2006, 05:57 PM

Take your grille out (two clips in front of radiator). That will give you access to the back side of the bumper. When drilling holes, be sure to center punch the location first, chrome is very hard, drill will wander without a good starting point.

Not enough room, bumper is easy to drop, disconnect end caps from fender, then nuts on back side of bumper.

campbell · 12-28-2006, 06:42 PM

Thanks.

I have the day off tommorow, so I will hit it in the morning.

appreciate the help.

12-28-2006, 05:21 PM	#1 (permalink)
campbell Senior Member Join Date: Dec 2006 Posts: 126 Gallery: 0	valence question Does anyone know how involved it is to remove the valence panel on a 95 RRC? i am planning on using the existing fog light harness and wiring to put in aux. lights in the mounting holes on top of the bumper, but I cant figure out hoe to bolt them on without taking the bumper off? There is no way to thread the respective lock washer and nut without doing so. Any advice?

12-28-2006, 05:57 PM	#2 (permalink)
choffa@comcast.net Member Join Date: May 2005 Location: Suburbs of Philadelphia, PA Posts: 60 Gallery: 0	Take your grille out (two clips in front of radiator). That will give you access to the back side of the bumper. When drilling holes, be sure to center punch the location first, chrome is very hard, drill will wander without a good starting point. Not enough room, bumper is easy to drop, disconnect end caps from fender, then nuts on back side of bumper. __________________ CJH 1990 Rangie Philadelphia, PA

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Land Rovers Only - Land Rover Forum Advertisement

12-28-2006, 06:42 PM	#3 (permalink)
campbell Senior Member Join Date: Dec 2006 Posts: 126 Gallery: 0	Thanks. I have the day off tommorow, so I will hit it in the morning. appreciate the help.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)