???Pulling the centering pin??? HTF did you do it

[rwarren92]

:Im trying to put a new drive shaft on my rover and I need to pull the pin out of the center of the 3 bolt flange that once attached to the Roto-flex. So far i have attached my slide hammer to the pin and have been beating the fool out of it all day, torching it and everything nothing will work any input would be much appreciated. Before I start breaking stuff.

[Swivelball]

I used exactly the same method, and it worked, but only after lots of "torching" and swearing.

[Joobaka]

read this and it made me chuckle...haven't had to replace the driveshaft yet but Ive had similar moments in the garage dropping a transaxle on the floor or swinging a engine out of a jeep cause the ghetto rigged cherry picker wouldn't hoist high enough....tools flew from my hands like i was pitching mlb and of course cussin up a storm...not fun when it happens but pretty funny after the job is said and done.

but good luck sir!