|Topic Review (Newest First)|
|07-16-2008 06:08 AM|
|TerryS||Electrical failure in the interlock circuit is very common, but not as common as the linkage being frozen from lack of use. DON'T force it, the top bracket, an aluminum casting, breaks very easily.|
|07-16-2008 05:58 AM|
Another thought... Just realized that '93 and up has the solenoid lock so you can't shift without being in neutral... I'd give this a read:
Range Rover Remedies
|07-16-2008 05:51 AM|
|Skidmarkart||Thanks all. Will let you know how it works out.|
|07-15-2008 03:58 PM|
|cellulararrest||Just don't kick it or anything. At least not too hard. I've broken two doing that...|
|07-15-2008 08:33 AM|
Originally Posted by ArmyRover View Post
|07-15-2008 08:24 AM|
|Skidmarkart||My apologies - years of 4wd'in has conditioned me to think in terms of 2wd -4h and 4l - you are right though, the little lever that goes between 4h (where it stays for normal driving) and 4l seems to be frozen. Like unwilling to move at all. I have followed the instructions in the manual, it just seems to be stuck in place. Do these rust or corrode? I don't want to force the movement.|
|07-14-2008 11:33 AM|
Like XM said full time 4wd on these rigs.
Going on that I'll assume your stuck in 4 high and want to go into 4 low.
If it hasn't been used in a long time the linkage could be froze up get underneath and clean and lube the linkage. Then try again. Linkage is located on the passenger side of the Rover if memory serves.
|07-14-2008 10:01 AM|
|XtremeMarine||I am confused by how you wrote your post. Your truck is ALWAYS in 4 wheel drive. It's a Land Rover. If it's just a problem between 4H and 4L then I can understand the question; but it seems like you are under the impression that you are driving around in 2wd???|
|07-14-2008 08:47 AM|
'94 doesn't want to shift into 4h
My rover seems not to want to shift into 4wd. I haven't tried to force the stick, but it seems like it doesn't want to go forward. I've tried stopped, in "N" , rolling in "N" and so on, it doesn't seem to want to go no matter what I do. I got the truck from LA, CA back in December and haven't tried to put it in 4wd yet. I know, I know I should have done it. No telling how long it was before I got it (probably years). Otherwise, she seems happy. What gives? Can anyone point me to a existing thread? TIA.