Land Rover Forums : Land Rover and Range Rover Forum - Reply to Topic
Thread: 2008 LR2 Vibration While Driving Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Land Rover Forums : Land Rover and Range Rover Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
11-26-2018 08:58 AM
Frank Ovanessians A problem I just came across:
1)Clicking at low speeds, vibration between 40-60 MPH on my LR2 2010 HSE 4X4.
2)Raised the rear wheels, chocked the front wheels
3)Checked for center bearing wear (2 center bearings) . NO WEAR
In order to check center bearing rubber, had to remove cross-members and exhaust hanger.
4)Checked for end play of driveshafts at both transmission end and rear axle end none.
5)When spinning rear tires, noticed the clicking occurring on sudden stops and starts even with wheels raised.
6) No wheel bearing issues, wheels rolled without getting stuck or noise.
7)Checked the six male torx screws going into the differential input and all 6 screws were relatively loose causing rotational play.
8)Re-tightened the 6 torx screws as tight as possible. This is difficult since there is not much room between side of driveline flange and bolts .
9)Assembled center bearings and exhaust hanger, drove car for 5 miles. No clicking or vibration.
10-02-2018 10:57 AM
MeanMrMustard I believe I figured it out! I was doing maintenance on my wife's car by cleaning her throttle body and her mass air flow sensor because her car kept detecting a vacuum leak. After I was done I was going to do the same to my LR2 and ran out of time to take off the throttle which I thought was the cause of the vibration. The mass air flow sensor is super easy to get to so I just needed up cleaning that only instead. Turns out that seemed to stop my vehicle from vibrating. Hope this helps.
08-06-2012 06:56 PM
Ddriver
2008 LR2 Vibration While Driving

My 2008 Land Rover LR2 (60 K) vibrates (like a under wobble throughout-not in the steering wheel) when I drive it. It happens at all speeds but is more noticeable between 60-70mph. It has new Michelin tires and rear brakes but it vibrated before I replaced the tires. The tires are balanced and the alignment has been checked. I've taken it to the tire shop, the dealership, and a repair shop. The drivers from these shops can feel it but they don't know how to fix it. Any ideas?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome