Land Rover and Range Rover Forum banner
Cancel

03 Disco II Not Starting

1324 Views 5 Replies 2 Participants Last post by  helievacpilot, 
K
My Disco II was starting with no problem until I decided it was a while ago since I replaced the plugs and wires. So I replaced not only the plugs and wires but I put a new eginition coil's (2) in.

Now when I try to start the truck it turns put lacks WHATEVER to start. Strange thing is the flahers start going off and the only way to get them to stop is by disconnecting the battery.

Lookin gfor answers???
Reply
Save
Like
1 - 3 of 6 Posts
K
Yes I followed the manual of installation. This isn't my first time doing this job. I did it 4 years ago and never had an issues. I've looked at and checked all my wires to the coil and connections to the sparks plugs. Not a real difficult job...... A pain in the ass but pretty basic. Any other suggestions?
Reply
Save
Like
K
Ok! Thanks! I'll look at the ineria switch to see if it was disconnected. What do you mean by cycle the key 3 times?

Thanks for the assistance!
Reply
Save
Like
1 - 3 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Land Rover and Range Rover Forum
A forum community dedicated to all Land Rover owners and enthusiasts. Come join the discussion about modifications, troubleshooting, engine swaps, maintenance, and more!
Full Forum Listing
Explore Our Forums
Discovery Series II Discovery Series I Range Rover Classic General Land Rover Discussion Discovery 3 / LR3
Top