Land Rover and Range Rover Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi,
Just installed Proud Rhino lift rods front and rear. Rear end is totally jacked up in the rear, but the fronts are on the bump stops. I get the messages Extended Mode, also more often Reset height if clear of obstacle.I am baffled. It's an easy job, but I'm lost.
 

·
very disco
Joined
·
1,519 Posts
It sounds like you need to calibrate your EAS without the rods, then reinstall.
 

·
very disco
Joined
·
1,519 Posts
You could try removing the lift rods, disconnecting the battery for some time, jacking up the front of the truck to a normal height, and reconnecting power/starting the truck.
 

·
Registered
Joined
·
2 Posts
I disconnected the battery from both terminals about half an hour ago, and am going to let it sit overnight. We shall see. Thanks for the input! I appreciate it!
 
1 - 5 of 5 Posts
Top