Land Rover and Range Rover Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I recently had my battery go dead. I replaced the battery and now the LR2 wont turn over. I push the button and nothing happens. Every thing else works, lights come on ect..... Maybe a fuse or something.... Start button lights up....

Any thoughts?
 

· Registered
Joined
·
242 Posts
Crash mode, it will need to be reset with a computer before it will allow crank.

Sometimes, if the CJB has reset crash mode status already, just clearing faults with a generic scanner will do the trick, as the PCM will kill cranking when it has a stored crash status fault.
 

· Registered
Joined
·
242 Posts
Only sometimes. It won't happen when the battery is just disconnected, but will sometimes when it discharges slowly, and the computers are 'turned on' with low voltage. Things get confused, and don't communicate correctly.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top