Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi guys,

what is the trick to seating a fuel sender in a 88rrc. I replaced mine and filled the tank. The sender sent the fuel gauge up to about 3/4 (no change there), but it only came down to about 1/4 before I nearly ran out of gas. Then it stayed there and wouldn't move.

I loosened the sender again and jiggled it, it seemed that the ball up/down motion was not constrained at all and reseated it. Now the gauge says a bit lower and still doesn't more..

hmmm any thoughts (multi function unit, gauge...)


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.