Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I bought a 97 se7 that the key switch was bad and was starting with a screwdriver. I want to put in a aftermarket key switch, but I have a question about the wiring. I found the wire that I believe is the acc(first notch), however I have 2 wires that energize in the run position(second notch). My question is can I put both wires under the same lug on the new switch?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top