Land Rover and Range Rover Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
96 disco. PO installed aftermarket heated seat elements in the manual seats and wired them directly to the battery. Concern is if I forget to turn them off before I get out of the truck they will drain the battery. How and where would I hook them up so they turn off and on with the ignition switch?
 

· Administrator
Joined
·
2,424 Posts
You could relay them using a keyed power to control the relay using a standard Bosch relay. Only 4 connections and no need for a switch although a switch may not be a bad idea.

1 Power wire from battery
2 power wire to seat heater elements
3 key on power of your choice
4 ground wire

If you choose to switch it I would switch the ground circuit with a standard 2 terminal switch
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top