Land Rover and Range Rover Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a 96 Discovery 300TDi which has developed an annoying vibration between approx 2250 rpm and 3000rpm through all the gears. It has 106k on the clock and I have recently had a new output shaft fitted, followed by a new clitch and rear propshaft. It seemed to start following the clutch/propshaft job and I have had the propshaft changed. Anyone have any ideas as to what the cause of the vibration might be?
 

· Registered
Joined
·
2 Posts
Discussion Starter · #5 ·
Thanks for the help. A new clutch seems to have done the job. The previous clutch was put in under warranty by the garage I bought it from when the output shaft went (March this year). It would seem that they only used a cheap one. The thrust bearing was worn and the springs were loose.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top