Land Rover and Range Rover Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Hey everyone,
I'm rebuilding my front brake calipers so i can avoid paying for remanufactured or new ones. The current ones have rust on them. What would y'all recommend the best way of getting all the rust off of them. I have a wire brush set for the drill to clean them out good but they may not get the job done alone.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top