Land Rover and Range Rover Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
New to forum, I have a 2003 Disco II HSE-7 with 140,xxx miles that has recently gone crazy. I have the 3 Amigo lights that came on when turning right, went out and then came back on when turning again and have stayed on since. Now my wife drove to store for Christmas shopping and the right front brake caliper wouldn't release. When I finally got there the brake had cooled and I drove it home, 5 miles approx., and it was smoking hot. I took wheel and caliper off expecting bad caliper, but it was not frozen. I pushed caliper back in, attempted to bleed but cannot get any pressure at caliper. Any suggestions on what I should attempt to do here. Bleed system or what...Any help would be appreciated. :help:help:help:wave:
 

· Premium Member
Joined
·
16,548 Posts
If it is a front caliper you will have to replace bot, most likely the pad and a full 2 quart DOT 4 brake flush.
Might want to consider using a set of Akebono ceramic pads for better stopping.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top