Land Rover and Range Rover Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Can anyone offer any advice please? Series 2 TD5 1998 45,000 miles. When hard or light braking at speed I am getting a severe vibration that is similar to a wheel wobble. I have replaced front discs and pads. Any suggestions please?
 

·
Registered
Joined
·
59 Posts
Are you sure that the rotors are are set correctly on the hubs?? Did you clean all the mating surfaces before reinstalling?? Do a runout check on both the hub flange and the installed rotor. I have warpped rotors in less than a day due to high heat... Did you have the vibration before you put new rotors on ???

PFZ
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top