Land Rover and Range Rover Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I have a 2003 disco 2. I'm in the process of a headgasket swap. I accidently pulled the wires out of the end of the plug (main harness) for the crank position sensor. I have a bosch sensor. the wires color code doesnt match. my hope is to solder the wires together and seal it up. how do i tell which wires go to what? the main harness has a blk wire,black with green dotted tracer and a pink wire. the sensor has a bare wire, a blk and a white wire. any ideas?

:dunno:
 

·
Registered
Joined
·
1,166 Posts
I have a 2003 disco 2. I'm in the process of a headgasket swap. I accidently pulled the wires out of the end of the plug (main harness) for the crank position sensor. I have a bosch sensor. the wires color code doesnt match. my hope is to solder the wires together and seal it up. how do i tell which wires go to what? the main harness has a blk wire,black with green dotted tracer and a pink wire. the sensor has a bare wire, a blk and a white wire. any ideas?

:dunno:
If you don't already have it, download RAVE and look in the wiring diagrams section.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top