Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
125 Posts
Discussion Starter · #1 ·
The rear bulkhead on my 109 is pretty well bent, and though I have straightened the capping, the ali sheet is far too stretched to acheive anything close to a tidy finish. Rather than just cover it up, I'm planning to use a bulkhead removal bar (similar to those inthe latest D90s), probably from Protection and Performance (

Does anyone have experience of these products, or know for certain that they will fit Series vehicles? Cheers.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.