Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

·
wjsj69
Joined
·
124 Posts
Discussion Starter · #1 ·
I've read this before, but I haven't seen a solution for my specific problem; (2000 disco 2 with home-made cdl linkage) only when I engage the cdl and after I hit the brake pedal, my brake light fuse blows, also locking out the safety solenoid for the shifter. The cdl dash light comes on when I hit the brakes but no brake lights due to the blown fuse. I've since removed the shifter solenoid, and I replace the fuse every time I'm done using the cdl. Did I miss a step electrically when I installed the cdl linkage? Or should I be looking for a short or bad component somewhere? sorry if this has been covered b4, but I can't find it..
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top