clunk clunk, i was thinking endlink but they all seem to be fine, even the bushing, so i'm lost. i'll get under there and look again.
clicking going over bumps
When i go over a bump and the truck moves side to side there is a clicking/clunking noise, but not when i got over it pefectly straight and hot when i'm driving. I dont think it is the axel or something like because there is no noise when turning or anything, i looked under the car and all the rods and bushing seems to look good. Im thinking it might be a Sway bar linkage but i looked at those and they all seem fine, or maybe a shock? but then why wount it only do it when the truck is moving side to side and not up and down..
Any imput?
Any imput?
1 - 5 of 8 Posts
Thanks for the post, no please go back in the hole you came from.Hailsharky said:Try drinking a lot of water and trying the same excersise. That clunking you are hearing is just your brain clamering about in that big thick skull of yours. It must be in need of more water.
Also, try eating dry packs of jello. It will disolve and mix to make a quiet cushion in your skull.
Cheers.
The problem was bad rear bushing
1 - 5 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Land Rover and Range Rover Forum
A forum community dedicated to all Land Rover owners and enthusiasts. Come join the discussion about modifications, troubleshooting, engine swaps, maintenance, and more!
Full Forum Listing
Recommended Communities
