Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I recently changed a rear wheel bearing on 2008 LR2. Wheel bearing change out went smoothly but the warning codes lite up like a Xmas tree after restarted engine. It appeared that the speed sensor was not functioning. Changed out the speed sensor and still getting same codes(ABS,HDC, and others). Engine does not operate properly on start up until you tramp on gas.
Any help would be appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top