Land Rover and Range Rover Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
I replaced my water pump but I have the old upper hose with the bleed screw molded in above the rad. I am wondering if there was a nut on the inside of the hose or if the hose just had threads casted that the screw went into? I am just worried that if there is a piece inside that it is now floating in my cooling system and will destroy my new pump, help please.
 

· Administrator
Joined
·
2,424 Posts
It is just a plastic screw cap in a threaded hole. Should not be any parts otherwise to fall in
 

· Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
cheers

ty, 2 days out in winter with a tarp over myself changing water pump with freezing rain and wind and then that happens, sucked. I then thru some tape over the hole, the stretchy stuff AND started the truck, it blew off, all over engine, I am a sore, bitter and cold rover owner.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top