Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
22 Posts
check the window ICU connection under the cubby. sometimes a little wiggle is all it takes and other times it just fails. it's 22 years old now. the 93 ICU i think should be the same as the 90-92 with just the quick 1 touch on the drivers window. Find someone parting. There is however a ground for the harness that's tied to a 13mm bolt holding the center console to the trans tunnel. Check that too.

Seat adjustment controls tend to fail now as well and are NLA like the window ICU. Mine would occasionally not work (usually after my wife moved it forward) and then it just worked all the time. I think someone retraced some of the circuit board or at least cleaned up some of the connections and got it working again. Check the web. it was someone on one of the US boards.

hope this helps
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top