Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys new to the site. I thought I would ask if any of you know if there is an alternate molding that will fit a Disovery 1 1996 SE7 ? When I purchased the vehicle the previous owner removed the trim and I have all these square punched holes as if a plastic trim clip could go in them although the original trim is stuck on with adhesive. Any help I would greatly appreciate it.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top