Land Rover and Range Rover Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
G' Day from a new member in Aus, any other Aussies here? I am a series 1 restorer, with 2 projects at the present. Current project is a 1951 80" called stubby, (lots of stubbies consumed during restoration) and a 1949 side plate 1600 yet to be started.

Mark. :drive:
 

·
Registered
Joined
·
146 Posts
There is a few of us here ,go down to the Regional Discussions and say hello in there also.

At the moment I have a Stage 1 V8 :D and a Rossignal Disco V8 :)


Adam :beer:
 

·
Registered
Joined
·
10 Posts
Hi there!

I'm a proud '95 V8i Disco owner from Ballarat, Victoria Australia - let me tell you, some AWESOME 4WD tracks around this country :drive:

I've had my rig about six months, and I'm just starting to do some decent stuff to it.

It's done about 220,000 k's, so it's been around. About that time of a Disco's life where stuff starts wearing out, as I found out - I have recently replaced the hoses, uni joint, and starter motor. Got it tuned and serviced, made it a completely new car.

Bought new wide profile Serengeti tyres, replaced the shockers, and got a UHF radio...

Next up on the list is an ARB bullbar, and also driving lights, a rear light, and a snorkel.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top