Land Rover and Range Rover Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I am about to embark on my most audacious endeavor.

I realize that I have a head gasket problem in a 2006 RR HSE with an AJ engine. Anyone with advice and pointers, please do not hesitate to spell them out.

I have mechanical knowledge to guide me thru. however, I believe that are special tools to be used, especially, with the removal and retention of the timing chain.

I will be starting the project soon.

Thank you.
 

·
Registered
Joined
·
3 Posts
I haven't read much on these vehicles yet but I just purchased the same one you have. Are they bad about blowing head gaskets? My 1991 Toyota supra is notorious for blowing head gaskets. Hopefully my RR doesn't do me like the supra has. Good luck with your HG job.
 
1 - 2 of 2 Posts
Top