Land Rover and Range Rover Forum banner
1 - 2 of 2 Posts

· very disco
Joined
·
3,025 Posts
I had mine out not too long ago. IIRC, you have only one fastener beneath that triangular beauty plate that pops off, then you just wrestle the piece off. It was easier to get back on than I expected, rear air and all.
 

· very disco
Joined
·
3,025 Posts
Again I’m going off of memory, but at least it was recently!

I only recall removing the one screw. Mine was a Phillips head which I thought was peculiar. If yours is a torx, I assume mine is not original lol.

yes, I believe the ducting was fixed to the back of the pillar shroud, and there was much upward/downward and gyrational movement to detach it
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top