[Maximumwarp]

Anyone have any special tips or tricks for getting the O- rings off the injectors? I'm afraid of damaging them if I just crank them off with a flathead screwdriver. I am replacing bc my head gasket kit came with new O rings, and while I don't think the ones on there currently were leaking, they look fairly dirty so might as well put new ones on.

 

[RWilson]

I just very carefully pried them up and over the ring on top. They seem to be pretty sensitive though, so it requires a lot of patience.

 

[Jagfixer]

Putting on new? Cut the old ones. Why save them?

 

[Maximumwarp]

That was poorly worded, sorry. I meant I was worried about damaging the injectors. They ended up being a little more flexible than I originally thought, and while the upper ring was slipped right off, the lower ring I stretched and then cut with an Xacto knife. They're all ready to go back on now! Thanks folks.