Land Rover and Range Rover Forum banner
Cancel

Injector O-ring removal

1004 Views 3 Replies 3 Participants Last post by  Maximumwarp, 
Maximumwarp
Anyone have any special tips or tricks for getting the O- rings off the injectors? I'm afraid of damaging them if I just crank them off with a flathead screwdriver. I am replacing bc my head gasket kit came with new O rings, and while I don't think the ones on there currently were leaking, they look fairly dirty so might as well put new ones on.
Reply
Save
Like
1 - 1 of 4 Posts
R
I just very carefully pried them up and over the ring on top. They seem to be pretty sensitive though, so it requires a lot of patience.
Reply
Save
Like
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Land Rover and Range Rover Forum
A forum community dedicated to all Land Rover owners and enthusiasts. Come join the discussion about modifications, troubleshooting, engine swaps, maintenance, and more!
Full Forum Listing
Explore Our Forums
Discovery Series II Discovery Series I Range Rover Classic General Land Rover Discussion Discovery 3 / LR3
Top