Oh, not sure about the RRs this one had the center section and full end caps on each side of the bumper. I removed the center and took a grinding wheel with a cutting disk on it to the end caps. The nice part was the crease was already there for me from the factory.... I just followed it around the cap. It was a little rough at first but a simple file smoothed out the underside.
Not a lot of planning on my part. Just something I started and seemed to finish with success. If I plan this stuff out too much, I plan myself out of it.
I can see, I need a skid plate for the front, that steering arm is begging to be bent.
I can build one pretty easy... if I make it out of aluminum would that be worth a damn or should I stick to steel. I think a little polished aluminum diamond plating would look pretty tough.