Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
I have recently bought a new (to me) 1998 4.6 HSE P38, The problem I have with it is it didn't come with any locking nut key.
the caps have been taken off and they have rusted over.
I have heard of a removal tool made by Irwin and others but am not sure if they would fit the large 27mm nuts. please could someone post a link or direct me to the right ones.
Cheers Chaps.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.