Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· '03 Disco SE
Joined
·
573 Posts
Driveshaft vibrations usually tend to be fairly slight, even if the joints are pretty far past it. Most of the time you replace the joints & centering ball the motion of the shaft will tend to line everything up, so even if you didn't rebalance it you should be ok.

My money's on something else. Maybe transmission or transfer case internals, torn rotoflex, torn engine mounts, etc.

Usually when the shafts fail it's because they seized up. The torque from the engine is plenty strong to snap the shaft, but not before it does damage to the weaker components like rubber and drive gears.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top