numerous sensor codes, limp mode, check engine, 3 amigos and more...

1562 Views 1 Reply 2 Participants Last post by Rovingvic, Jan 9, 2015

rapac

Discussion Starter · Jan 9, 2015

Hi all, i have 99 Disco II with over 300,000 miles on it, been running well for a while, just today the m and s lights flash and it has gone into limp mode. read codes with abs reader and it came up with the following codes... (get ready)

Front left sensor output too low
Rear right sensor output too low
Front right sensor signal erratic
Front left sensor signal erratic
Rear right sensor signal erratic
shuttle valve switch electrical failure
Pump relay open circuit
Front right sensor output too low

need some help on what should/can be done. :help

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.