Land Rover and Range Rover Forum banner
Cancel

O2 Sensor multi plug destroyed

1034 Views 2 Replies 2 Participants Last post by  dismalrobot, 
D
I am replacing the front O2 sensors on my 03 Disco and found that the plug on the driver's side is shattered. There is nowhere for the new sensor to connect. Any ideas as to the easiest way around this? I am assuming I need to cut the wires and replace the plug. However, it's in such a tight spot and I don't know where I can buy the plug.

Thanks in advance for any ideas.

Attachments

See less See more
Reply
Save
Like
1 - 3 of 3 Posts
P
I probably have a wiring harness with an intact connector.
Reply
Save
Like
D
Cool!

PTSchram said:
I probably have a wiring harness with an intact connector.
Click to expand...
Cool! If i don't find one at the local salvage yard I'll be contacting you. I was hoping to find one at a Pull-A Part lot yesterday but all but one place was closed and they only had a 97 disco in the lot.

If I find one I think I'm just going to cut the passenger side off so I have a good amount of wire to work with. Also, it doesn't look like it will be too difficult to do the rewire from the top.
Reply
Save
Like
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Land Rover and Range Rover Forum
A forum community dedicated to all Land Rover owners and enthusiasts. Come join the discussion about modifications, troubleshooting, engine swaps, maintenance, and more!
Full Forum Listing
Explore Our Forums
Discovery Series II Discovery Series I Range Rover Classic General Land Rover Discussion Discovery 3 / LR3
Top