Land Rover and Range Rover Forum banner
1 - 20 of 25 Posts

· Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
We are presently parting out 1994,1995,1996,1997,1998,1999, 2000,2001,2002,and 2003 Discovery 1's and Discovery 2's. We have a lot of body, drive ,train, motor, electrical,rims and accesories.
We take paypal to this address and any major credit card ( call it in to us).

Some of the parts we have for sale are as follows:

Engines: 3.5L, 3.9L, 4.0L, 4.2L, 4.6L as well as 2.25L 4 cyl 2.5L NADA 6 cyl gas. Diesels are also availible Natural aspiration and Turbo charged. $850 and up

Transfer cases: Lt230, Lt230se, Borg Warner Classic and P38a. Series transfer boxes are Limited supply. Prices from $400 on up

Transmissions: ZF 4HP22 many years, R380 5 spds, Lt77s & Lt77q 5 spds Prices from $480 on up

All sensors, switches and modules for all years availible. Prices starting at $5.00

Axles, drive shafts, swival balls and housings, cv joints, bearings, hubs, differentials. Prices from $15.00

Body panels and moldings, and trim, just tell us what color you need. prices from $5.00 on up.



Regards,

John Miller
Tidewater Rovers
201 Beval Rd.
Wilmington, NC 28401
1.866.TW ROVER (toll Free)
(1.866.897.6837)
910.763.3335 o
910.538.2102 m
email us at [email protected]
Our web site is www.Tidewaterrovers.com

--------------------------------------------------------------------------------
 

· Registered
Joined
·
24 Posts
2000 Discovery LR

Hey - Could you quote me on a Mass Airflow Meter for a LR 2000 Disco? I am about to purchase one through a website, send me a pic and cost please...

Private message is cool, I don't want your free "rave" music though :)
 

· Registered
Joined
·
23 Posts
parts needed

what would the costs be for the following parts on a 96 Disco 1

1) Stock front bumper complete

2) Abs sensors for front and rear

3) Little cover underneath the front seats where the 6 disc is I need both sides it is about 4 inches by about 9 inches dont know what it is called

4) The small plate where the coin space is (The plate is about 1/2 inch by about 3 inches and keeps the coins from sliding out)

5) I need two sunroof motors
also about how much shipping for the bumper to 80602
Thanks a lot - Jason
 

· Super Moderator
Joined
·
743 Posts
curedude said:
Private message is cool, I don't want your free "rave" music though :)
Just an FYI, the RAVE cd in which he mentioned is the parts, diagnostic, and schematic info on the Land Rover line of vehicles. A very handy item to have.
 

· Mod. --- I'm watching you
Joined
·
319 Posts
I'm looking for a DII 1999.5 Mass air flow sensor, and a trailer wiring mounting backet.
 

· Registered
Joined
·
41 Posts
Discussion Starter · #9 ·
I dot check this site all of the time. If you have any requests:

Give me a call or email me.

John Miller
Tidewater Rover
201 Beval Rd.
Wilmington, NC 28401

1866.TW ROVER (toll free)
910.763.3335 o
910.538.2102 m
 

· Registered
Joined
·
130 Posts
I just bought the Window lift ECU off your ebay store. Good deal by the way, Thanks :buttrock: . Do I get rave CD now? :D
 

· Premium Member
Joined
·
3,190 Posts
This thread is over 11 years old!

Now, if you are looking for an LT230 for your '95 Classic, I happen to have a very late version, commonly called the LT230Q because it was literally the quietist of all the LT230's Rover offered on the DI. I also have the frame mount and CDL. The only part I am missing for a full Borg Warner to LT230 conversion is the front driveshaft but I '' sure I can locate one for you.

As an alternative, I also have a good Borg Warner from a '95 Classic I recently parted.
Let me know if I can be of help.
 
1 - 20 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top