Land Rover and Range Rover Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
122 Posts
Discussion Starter · #1 ·
I have the new PAS Pump ready to be installed onto the bracket. I cannot get the new pump to line up so that I can bolt it in. I get one bolt in and the other is just off so that I cannot fit the bolt through.

Has anyone had this issue?
 

·
Registered
Joined
·
122 Posts
Discussion Starter · #3 ·
I got another pump from Napa same issue. We were able to thread a bolt from the opposite side and wedge it in.

I would recommend going to BPUtah if you have the time, unfortunately I am traveling and using my Father's garage as the Disco doesn't fit into our garage.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top