Land Rover and Range Rover Forum banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
We have a '95 lwb with a bad seat switch. It has about 10 wires conected by a rivet type of fastener on the underside. The replacement part I bought has 11 "male" prongs and is completely different from what is currently installed. What is the solution to this problem? Thanks Robert
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.